The PILOT B10MXO has ten inputs, which are
opto-coupled to the electronic circuits inside the enclosure. This means, that the
input signals are galvanic insulated from the outputs. It means also,
that it is possible to connect input signals with a wide range of
voltage, from 12 VAC/DC to 240 VAC/DC.
The unit has one output relay.
There are push buttons for Reset and Test.
Power, failure contacts and relay outputs are connected at the rear of the unit.
The PILOT B10MXO-2 is similar to the PILOT B10MXO, but the unit
has two output relays, programmable to be activated for a selected
input channel (example: two different alarm priorities A and B).
When a failure occurs, the output relay is activated after the
programmed delay time and the alarm LED lights with a steady light.
Simultanously the corresponding channel LED indicates the position
of the failure with a flashing light.
PILOT B10MXO and MXO-2 can be delivered with:
- built in transformer for 110 or 230 VAC power input
- built in adapter for 48 - 110 VDC power input
- protected enclosure for IP 54
- se also Accessories
For more information plese send a message to:
PILOT Monitor System