The Pilot B10MX-2 has ten alarm channels for
closing input failure contacts, all individually programmable to an
alarm delay time, specified by the customer.
The PILOT B10MX-2 is equipped with two output relays, programmable for
two priorities by means of program jumpers (A or B alarm).
There are push buttons for Reset and Test.
Power, failure input contacts and relay outputs are connected
to terminals at the rear of the unit.
The PILOT B10MXB-2 is similar to the B10MX-2 but has ten alarm channels for breaking input failure contacts .
When a failure occurs, one of the programmed output relays (A or B)
is activated after the programmed delay time and the alarm LED (A or B)
lights with a steady light.
Simultaneously the corresponding channel LED indicates the position
of the failure with a flashing light.
PILOT B10MX-2 and B10MXB-2 can be delivered with:
- built in transformer for 110 or 230 VAC power input
- built in adapter for 48 - 110 VDC power input
- protected enclosure for IP 54
- se also Accessories
For more information plese send a message to:
PILOT Monitor System